If there is an active leak of water, apply point hydraulic water.

Therefore, you need to carefully use industrial hair dryers or heat guns to accelerate the work. If there is an active leak of water, apply point hydraulic water. When the water is stopped, dry the problem surface and cover with sealant. When working with wet deformation seams, they need to be cleaned of dirt and garbage, dried with flexible heating cords, gas burners or heat guns. Water leaks are eliminated using a drainage system, injections or hydraulics. The mouth of a dry and cleaned seam is coated with a sealant and after a time when the sealant will have the necessary viscosity and stickiness into the seam, pre -numbered and chopped harnesses are inserted. From the time of the tourniquets are recorded in the seams using glue-meters, you should wait about seven hours so that the glue grabs well and smear the joints of the tourniques with sealant, thereby providing continuous waterproofing.